Compressive and Flexural Strength Behavior of Ultra-high Performance Mortar Reinforced with Cellulose Nano-fibers

Steve W.M Supit, Tomoya Nishiwaki

Abstract


Cellulose fibers, because of their chemical and physical characteristics, are compatible with other materials to be used for the production of building components. This paper presents the influence of using cellulose nano fibers (CNFs) made from plant-derived cellulose as a reinforcement in ultra-high performance (UHP) mortar. In this study, the dispersion method of CNFs using manual and mechanical mixing was also observed. The effects of different dosage of CNFs, namely, 0.005%, 0.01% and 0.015% by wt. of binders (premixed low-heat cement and silica fume) with a constant waterto binder ratio of 0.15, were evaluated based on the compressive and flexural strengths at the seventh day after steam curing. Results show that the highest compressive strength value of 184MPa was reached by UHP mortar sample containing 0.005% CNFs by wt. of binders. However, addition of more CNFs content up to 0.015% did not result in further improvement. Based on load-CMOD curves, UHP mortar reinforced with 0.005% CNFs was found most effective in enhancing the energy absorption capacity and toughness index with flexural strength at peak load of 14.44MPa (36% higher than control UHP mortar). The results indicate the well-post crack behavior of CNFs mortars in comparison with control UHP low-heat cement mortar. Moreover, Scanning Electron Microscopy (SEM) analysis shows that the phenomenon of bridging effect of CNFs could not be significantly detected since the short fiber might be fractured under loading due to less bonding. Furthermore, this study concludes that even a low volume fraction, i.e 0.005%, of CNFs is very sufficient in increasing the ductility of ultra-high performance mortar.

Keywords


cellulose nano-fibers; compressive; flexural; dispersion; SEM.

Full Text:

PDF

References


N. Banthia, “Fiber reinforced comcrete for sustainable and intelligent infrastructureâ€. Proceeding on the 1st International conference on Sustainable Built Environment Infrastructures in Developing Countries, ENSET Oran (Algeria), October 12-14, 2009.

V. Rudnov, V. Belyakov, and S. Moskovsky, “Properties and design characteristics of the fiber concrete.†Procedia Engineering, International Conference in Industrial Engineering (ICIE 2016), vol. 150, pp. 1536-1540, 2016.

K. Krayushkina, T. Khymerik, O. Skrypchenko, L. Moshkovskyi, and V. Pershakov, “Investigation of fiber concrete for road and bridge buildingâ€. Procedia Engineering, vol. 187, pp. 620-627, 2017.

S.P. Shah, M.S. Konsta-Gdoutos, and Z.S. Metaxa, “Exploration of fracture characteristics, nanoscale properties and nanostructure of cementitious matrices with carbon nanotubes and carbon nanofibersâ€. Fracture Mechanics of Concrete and Concrete Structure – Recent Advances in Fracture Mechanics of Concrete-B.H.Oh, et al. (eds). Korea Concrete Institute, Seoul, ISBN: 978-89-5708-180-8, 2010.

Z.S. Metaxa, M.S. Konsta-Gdoutos, and S.P. Shah, “Mechanical properties and nano structure of cement-based materials reinforced with carbon nanofibers and polyvinyl alcohol (PVA) microfibersâ€. Proceeding at the Advances in the Material Science of Concrete - Session at the ACI Spring 2010 Convention, vol. 270, pp. 115-126. Dec. 2010.

E.E. Gdoutos, M.S. Konsta-Gdoutos, P.A. Danoglidis, and S.P. Shah. “Advanced cement based nanocomposites reinforced with MWCNTs and CNFsâ€. Front. Structural. Civil Engineering, vol. 10(2): 142-149, 2016.

N. Yazdani, V. Mohanam. “Carbon nano-tube and nano-fiber in cement mortar: Effect of dosage rate and water-cement ratioâ€. International Journal of Material Science, vol. 4, Issue 2: pp. 45-52. 2014.

R.K. Abu Al-Rub, Z. Grasley. Carbon nanotubes and carbon nanofibers for enhancing the mechanical properties of nanocomposite. Journal of Materials in Civil Engineering, pp. 1028-1034. 2011.

F. Sanchez, L. Zhang, and C. Ince. “Multi-scale performance and durability of carbon nanofiber/cement composites. Nanotechnology in construction 3†in Bittnar et al, (eds), 3rd International Symposium on Nanotechnology in Construction, May 31-June 2, 2009, Prague, Czech Republic. 2009.

M. Sappakittipakorn, and N. Bantia. “Corrosion of rebar and role of fiber reinforced concreteâ€. Journal of Testing and Evaluation, vol. 40, No.1. 2012.

L. Jiao, M. Su, L. Chen, Y. Wang, H. Zhu, and H. Dai. “Natural cellulose nano-fibers as sustainable enhancers in construction cementâ€. PLOS ONE. DOI:10.1371/journal.pone.01682422. 2016.

A. Kafy, H.C. Kim, L. Zhai, J.W. Kim, L.V. Hai, T.J. Kang, J. Kim. “Cellulose long fibers fabricated from cellulose nanofibers and its strong and tough characteristicsâ€. Scientific Reports, vol.7, No. 17683. 2017.

S. Kawashima, and S.P. Shah. “Early-age autogenous and drying shrinkage behavior of cellulose fiber-reinforced cementitious materialsâ€. Cement and Concrete Composites, vol.33, pp.201-208. 2011.

R. Moon, G.Shueneman, and J. Simonsen. “Overview of cellulose nanomaterials, their capability and applicationsâ€. Journal of the minerals, metals and materials society, vol. 68, pp. 2383-2394. 2016.

N. Bhalerao, A.S. Wayal, P.G. Patil, and A.K. Bharimalla. “A review on effect of nano cellulose on concreteâ€. International Journal of Civil and Structural Engineering Research, vol.3, pp. 251-254. 2015.

S.J. Peters, T.S. Rushing, E.N. Landis and T.K. Cummis, “Nanocellulose and microcellulose fibers for concreteâ€. Journal of the Transportation Research Board, No.2142, pp. 25-28. 2010.

Z. Li. “Proportioning and properties of ultra-high performance concrete mixtures for application in shear keys of precast concrete bridges.†Phd Dissertation. Clemson University. 2015.

L. Rosato, M. Stefanidou, G. Millazo, F. Fernandez, P. Livreri, N. Muratore, L.M. Terranova Study and evaluation of nano-structured cellulose fibers as additive for restoration of historical mortars and plasters. Proceedings on the 13th International Conference on Nanoscience and Nanotechnologies and 9th International Symposium on Flexible Organic Electronics, vol. 4, pp. 6954-6965. 2017.

H. Shin, D. Yoo, J. Lee. “Development of 300 MPa ultra-high-strength mortar through a special curing regimeâ€. Construction and Building Materials, vol. 171, pp. 312-320. 2018.

Standard test method for flow of hydraulic cement mortar. American Society for Testing and Materials Standard C 1437, Pennsylvania, USA. 2012.

S. Kwon, T. Nishiwaki, H. Choi, H. Mihashi. “Effect of wollastonite microfiber on ultra-highperformance fiber-reinforced cement-based composites based on application of multi scale fiber-reinforcement systemâ€. Journal of Advanced Concrete Technology, vol. 13, pp. 332-344. 2015.

R. Mejdoub, J. Sunol, H. Hammi, and M. Khitouni. “Nanofibrillated cellulose as nanoreinforcement in Portland cement: Thermal, mechanical and microstructural propertiesâ€. Journal of Composite Materials, vol. 51(17), pp. 2491-2503. 2016.

F. Pan, J. Huang, and X.Wang. “Preparation and characterization of micro and nano cellulose fibers via electroless Ni-P composite coatingsâ€. Journal of Nano Materials Nano Engineering and Nano Systems, vol. 230, pp. 213-221. 2016.

O. Onuaguluchi, D.K. Panesar, M. Sain. “Properties of nanofibre reinforced cement compositesâ€. Construction and Building Materials, vol. 63, pp. 119-124. 2014.

T. Fu, R.J. Moon, P. Zavattien, J. Youngblood. “Cellulose nanomaterials as additive for cementitious materials. Jawaid et al (eds) Cellulose-Reinforced Nanofibre Composites. Woodhead Publishing Series in Composites Science and Engineering. ISBN: 978-0-08-100857-4. 2017.

Tayeb, A, Amini, E, Ghasemi, S and Tajvidi, M. “Cellulose nanomaterials-binding properties applications: A reviewâ€. Molecules, vol. 23, 2684. 2018.

M. Ardanuy, J. Claramunt, G. Pares, E. Aracri, and T. Vidal. “Nanofibrillatedcellulose as reinforcement for high performance cement mortar compositesâ€. Proceeding on the 15th European Conference on Composite Materials, June, 24-28, Venice, 2012.

L. Vandewalle. “Postcracking behavior of hybrid steel fiber reinforced concreteâ€. Proceeding on the 6th International conference on fracture mechanics of concrete and concrete structures in Catania, Italy, vol. 3, pp. 1367-1376, 2007.




DOI: http://dx.doi.org/10.18517/ijaseit.9.1.7506

Refbacks

  • There are currently no refbacks.



Published by INSIGHT - Indonesian Society for Knowledge and Human Development