Remote Pressure Water Valve Control System Based on PLC

W. Widhiada, I. M. Widiyarta, I.N.G. Antara, I.N. Budiarsa, I.M.G. Karohika

Abstract


Currently, valve operations use manual processes to safeguard water pressure and distribution to the Regional Water Company. Conventional systems are still used upon operations in opening and closing the valve. This method requires operators to rotate the valve by hand to maintain the distribution and water pressure's stability to the Regional Water Company. It would be more efficient if operators can maintain the distribution and water pressure stability without going to the location where the valve is located. A PLC and Android-based distribution valve remote control system design is planned to be produced from this research. Control commands are done via HMI display on Android to the PLC via PC and server to control the gearbox motor located on the valve. The pressure analysis shows that there are differences before the control system is installed. The pressure tends to be under 4 bar and is less stable. However, after the control system is installed, it tends to be more stable, between 4 bar and 4.5 bar. The data flow results show a difference in the flow before the control system is installed. The distributed flow tends to be below the number 180 l / s and is less stable. After installing the control system, the flow is more stable and increased from originally at an average of 144.4 l/s to 171.2 l/s, a difference of 26.8 l/s. 


Keywords


Water pressure valve; PLC control; flow; stable.

Full Text:

PDF

References


E. J. M. Blokker and P. G. Schaap, “Particle Accumulation Rate of Drinking Water Distribution Systems Determined by Incoming Turbidity,†Procedia Engineering, vol. 119, pp. 290–298, 2015, doi: 10.1016/j.proeng.2015.08.888.

G. Gençoğlu and N. Merzi, “Minimising Excess Pressures by Optimal Valve Location and Opening Determination in Water Distribution Networks,†Procedia Engineering, vol. 186, pp. 319–326, 2017, doi: 10.1016/j.proeng.2017.03.254.

T. Lydon, P. Coughlan, and A. McNabola, “Pressure management and energy recovery in water distribution networks: Development of design and selection methodologies using three pump-as-turbine case studies,†Renewable Energy, vol. 114, pp. 1038–1050, Dec. 2017, doi: 10.1016/j.renene.2017.07.120.

I. M. G. Karohika and I. N. G. Antara, “Gasket Process Parameter in Metal Forming,†IOP Conference Series: Earth and Environmental Science, vol. 248, p. 012044, Apr. 2019, doi: 10.1088/1755-1315/248/1/012044.

A. Dharma, N. Budiarsa, N. Watiniasih, and N. G. Antara, “No Cost – Low Cost Compressed Air System Optimization in Industry,†Journal of Physics: Conference Series, vol. 989, p. 012002, Apr. 2018, doi: 10.1088/1742-6596/989/1/012002.

J. Garrigós, J. M. Molina, M. Alarcón, J. Chazarra, A. Ruiz-Canales, and J. J. Martínez, “Platform for the management of hydraulic chambers based on mobile devices and Bluetooth Low-Energy motes,†Agricultural Water Management, vol. 183, pp. 169–176, Mar. 2017, doi: 10.1016/j.agwat.2016.10.022.

N. Wirastuti and C. Emehel, “Handover Scenarios for Mobile WiMAX and Wireless LAN Heterogeneous Network,†TELKOMNIKA Indonesian Journal of Electrical Engineering, vol. 12, no. 8, Aug. 2014, doi: 10.11591/telkomnika. v12i8.6110.

N. M. A. E. D. Wirastuti, Ni Putu Lintang Anggitiadewi, Nyoman Pramaita, "Pulse shaping methods for inter carrier interference reduction in OFDM system", TELKOMNIKA Telecommunication, Computing, Electronics and Controâ€, Vol. 18, No. 5, October 2020, pp. 2276~2283ISSN: 1693-6930.

R. Bayindir and Y. Cetinceviz, “A water pumping control system with a programmable logic controller (PLC) and industrial wireless modules for industrial plants—An experimental setup,†ISA Transactions, vol. 50, no. 2, pp. 321–328, Apr. 2011, doi: 10.1016/j.isatra.2010.10.006.

M. T. Ozdemir and A. Orhan, “An Experimental System for Electrical and Mechanical Education: Micro Hydro Power Plant Prototype,†Procedia - Social and Behavioral Sciences, vol. 47, pp. 2114–2119, 2012, doi: 10.1016/j.sbspro.2012.06.959.

E. Creaco and G. Pezzinga, “Multiobjective Optimisation of Pipe Replacements and Control Valve Installations for Leakage Attenuation in Water Distribution Networks,†Journal of Water Resources Planning and Management, vol. 141, no. 3, p. 04014059, Mar. 2015, doi: 10.1061/(ASCE)WR.1943-5452.0000458.

I. N. Budiarsa, I. D. G. A. Subagia, I. W. Widhiada, and N. P. G. Suardana, “Characterisation of Material Parameters by Reverse Finite Element Modelling Based on Dual Indenters Vickers and Spherical Indentation,†Procedia Manufacturing, vol. 2, pp. 124–129, 2015, doi: 10.1016/j.promfg.2015.07.022.

I. N. Budiarsa, I. N. G. Antara, I. M. G. Karohika, I. W. Widhiada, and N. L. Watiniasih, “Identification Plastic Properties of Spot-Welded Joints Using the Instrumented Indentation Technique,†IOP Conference Series: Materials Science and Engineering, vol. 811, p. 012020, May 2020, doi: 10.1088/1757-899X/811/1/012020.

W. Widhiada, N. S. Kumara, and T. G. T. Nindhia, “ANALYSIS of Control Force Grasping for a Multifunctional Five Fingered Robot to Pick-up Various of Components,†MATEC Web of Conferences, vol. 59, p. 05004, 2016, doi: 10.1051/matecconf/20165905004.

W. Widhiada, I. N. G. Antara, I. N. Budiarsa, and I. M. G. Karohika, “The Robust PID Control System of Temperature Stability and Humidity on Infant Incubator Based on Arduino AT Mega 2560,†IOP Conference Series: Earth and Environmental Science, vol. 248, p. 012046, Apr. 2019, doi: 10.1088/1755-1315/248/1/012046.

M. R. Anwar, O. Anwar, S. F. Shamim, and A. A. Zahid, “Human Machine Interface Using OPC (OLE for Process Control),†in Student Conference on Engineering, Sciences and Technology, Karachi, Pakistan, 2004, pp. 35–40, doi: 10.1109/SCONES.2004.1564766.

W. Widhiada, I. N. G. Antara, I. N. Budiarsa, and I. M. G. Karohika, “The Robust PID Control System of Temperature Stability and Humidity on Infant Incubator Based on Arduino AT Mega 2560,†IOP Conference Series: Earth and Environmental Science, vol. 248, p. 012046, Apr. 2019, doi: 10.1088/1755-1315/248/1/012046.

L. M. Fernández-Ahumada, J. Ramírez-Faz, M. Torres-Romero, and R. López-Luque, “Proposal for the Design of Monitoring and Operating Irrigation Networks Based on IoT, Cloud Computing and Free Hardware Technologies,†Sensors, vol. 19, no. 10, p. 2318, May 2019, doi: 10.3390/s19102318.




DOI: http://dx.doi.org/10.18517/ijaseit.11.3.14486

Refbacks

  • There are currently no refbacks.


Published by INSIGHT - Indonesian Society for Knowledge and Human Development